scruti-documents

TeX source file for ESF and scrutineering

ESF 2.0 TODOs

• BSPD

  • Schematic
  • Datasheet of used TS current sensor
  • Detailed schematic including all remote circuitry (e.g. brake pedal, current sensing).
  • Provide an explanation of SCS signal implementation failure mode and effect analysis per T11.9.2.
  • Provide latching capability explanation/simulation.
  • Step-by-step walkthrough of the technical inspection BSPD test procedure.

• SDC

  • AMS & IMD Latching
  • Top-level schematics with all switching elements.
  • Provide latching capability explanation/simulation (AMS and IMD).
  • Current consumption
  • Describe overcurrent protection

• TSAL

  • Detailed TSAL schematic, including all remote circuitry (DC-link and TSAC output)
  • TS Accumulator
    • Accumulator TSAL
    • Accumulator TSAL - Voltage detection
    • Accumulator TSAL - Relay state detection
    • Dashboard
  • (DC) Vehicle Side Voltage Detection
  • TSAL driver board and DC-link voltage detection
  • Vehicle TS Schematic voltage measurement, AIR and precharge relay state detection, red and green TSAL circuitry.
  • Provide latching capability explanation/simulation.
  • Provide an explanation of SCS signal implementation, failure mode and effect analysis per T11.9.2

• TS Discharge Circuit

  • Schematic
  • Relay/MOSFET (or equivalent) datasheet
  • Resistor (or equivalent) datasheet
  • High-level schematic of the discharge circuitry, highlighting components in the discharge power path (e.g. DC-link capacitors and their connection, switching devices, and resistors).
  • Proof that all components in the discharge power path can permanently handle maximum TS potential (calculations/simulations, component mounting method if necessary).

Categories for FS Czech ESF Addendum are BSPD, SDC, TSAL and Discharge.

• Documents must be submitted via the FS Czech Portal by 13:00 CEST, May 9th, 2025. Teams will receive a notification once their document has passed the review or if any changes are required. We will prioritize first-time submissions and cannot guarantee timely reviews for resubmissions.
• Each category must be submitted as a standalone PDF named in the following format: E###_TeamName_ESF_DocType.pdf (where ### is the car number and DocType is one of BSPD, SDC, TSAL, or Discharge).
• General rules:
  • Searchable document with part numbers included (except for non-critical low-voltage and low-power passive components - where component values are sufficient).
  • Short introduction to the circuitry, top-level schematic if needed for clarity.
  • Clear signal mapping, especially if the circuitry spans multiple PCBs / car locations.
  • Any used abbreviations (except those used in current Formula Student Rules) have to be explained.
  • If needed, include links to publicly hosted datasheets (preferred over attaching files).