V0.7.1
MVBMS:
- new outline
- removed UART
- added resistance to DNP resistors for V_{ref}
- LEDs are controlled by PWM 
- added PWM for inverters with PWM_INV_COOLING
- added many testpoints

V0.7.2
MV_Abnehmerplatine:
- new outline
- added a second GND and 3V3 pin to the connector
- made sure the pin layout of the connector is equivalent to the one on the MVBMS
- kept the 14 tmp1075 sensors
- finished the layout of the MV-Abnehmerplatine

V0.7.3 
MV_Abnehmerplatine:
- rechecked the distance between the traces leading to the battery cells and moved them around accordingly

MVBMS:
- moved RGB LED pins to TIM4 from TIM3
- moved PWM_BAT_COOLING to TIM3CH3
- moved PWM_INV_COOLING to TIM15CH1
- moved 60V_ENABLE to TIM2CH1
- PMEG3015EJ for the CURRENT_MEASUREMENT to prevent reverse voltage
- add an extra connector for the cooling fans that cool the ESCs/inverters
- fixed some traces and some zones

V0.7.4 
- added more documentation 

MV_Abnehmerplatine:
- aligned the connectors to the MVBMS connector
- slight changes to the outline for the connector
- fixed some zones

MVBMS
- new outline 

V0.8.1
new outlines for the MVBMS and Abnehmerplatine
added more photos under documentation


MV_Abnehmerplatin:
- the right side of the PCB is now smaller

MVBMS:
- added a 1MBit I2C EEPROM to save data of the battery#
- combined everything that goes to the ESC into one connector
- both battery cooling fans are now on one connector
- ESC cooling and battery cooling fans can be controlled pwm or voltage controlled
- PRECHARGE and RELAY connectors are now one connector

- renamed PWM_BAT_COOLING to BAT_COOING_PWM 
- renamed 60V_ENABLE to BAT_COOING_ENABLE
- renamed PWM_PG_Fan_1/2 to ESC1/2_PWM
- renamed PWM_INV_COOLING to ESC_COOLING_PWM
- added ESC_COOLING_ENABLE for voltage contol of the ESC cooling fans
- connected V_{ref} to GPIO 2 of the ADBMS. With this, it can be detected if the current sensor is recieving enough voltage
- layout:
    - Container layout is now better, the connectors have meaningful positions
    - moved all connectors to the front including the debug header

V0.9-cable
MV_Abnehmerplatine:
- switch from pads to through holes
- extended the layout to the middle of the busbars for the through holes

V0.9-pogo
MV_Abnehmerplatine:
- first sketch is done

V0.9.1-pogo
-   deleted V0.9-cable because the PCB for pogo could also be used with a cable
-   fixed up the zones 
-   2->4 layers with 2.4mm core and 0.188mm prepreg (increasing the thickness of the copper layers is taken from thickness of the core)
-   created a proper symbol and footrint for the 0921-1-15-20-75-14-11-0 which is the one I have decided on

V0.9.2
-   added dip switch for open wire detection
-   added PMEG3015EJ Diodes to RELAY_ESC/BAT_SIDE to pretect against funny business

V0.9.3
MV_Abnehmerplatine
- new layout: recentered the temperature sensors and pogo pins.

V0.9.4
MVBMS:
- removed screw holes next to the MV_Abnehmerplatine connector